RS5005 Mono automatic site adaptation - English
The Mono system adapts to the installation after power-up. Allow that process to finish, inspect the noise/status indications and test the intended tags at the final location.
Applicability
RS5005 Mono assembly only; the 95100 transmitter/receiver reference is a separate configuration.
Mono automatic site adaptation
The Mono system adapts to the installation after power-up. Allow that process to finish, inspect the noise/status indications and test the intended tags at the final location.
If the system is moved, repeat the setup in the new environment. Keep nearby stored tags and interference sources outside the test area; the separate 95100 transmitter/receiver procedure is not applied to this Mono board.
Before handover
- Identify the controller and revision before applying a menu or wiring reference.
- Test the actual tags with normal store equipment operating, then retain the accepted settings.
Document information
The downloadable original is in English. This English online reference summarizes the applicable selection or operating task. The source does not identify a confirmed revision number.
