AS4007 TST1050 switch-based setup - Chinese
The documented TST1050-Z master and TST1050-P slave use switch-selected setup for phase and per-channel sensitivity. After an adjustment, return the relevant setup switch to its operating position to save the selection.
Applicability
AS4007 with TST1050-Z/P hardware described in manual V1.3. Switch labels and save behaviour must match that revision.
TST1050 switch-based setup
The documented TST1050-Z master and TST1050-P slave use switch-selected setup for phase and per-channel sensitivity. After an adjustment, return the relevant setup switch to its operating position to save the selection.
Device-compatibility mode, split transmit/receive operation and recognition accuracy are separate choices. Lower recognition accuracy can increase response speed while also increasing false-alarm risk in noise, so test the intended tags under normal store operating conditions.
Site testing and noise diagnosis
Power and test the proposed position before permanent fixing. If interference prevents stable operation, move the equipment or noise source, or reduce the installation spacing.
The documented main board separates tag-signal and noise indicators. Use them to distinguish nearby active tags from a noisy environment, then set sensitivity and phase for the site.
Standard and compatible controller modes have different interference tradeoffs. Confirm the supplied board and use the corresponding technical instructions for wiring and commissioning.
Before handover
- Identify the controller and revision before applying a menu or wiring reference.
- Test the actual tags with normal store equipment operating, then retain the accepted settings.
Document information
The downloadable original is in Chinese. This English online reference summarizes the applicable selection or operating task. The source identifies version V1.3.
